diff --git a/NucuCar.Sensors/Readme.md b/NucuCar.Sensors/Readme.md
index 2333a98..46ecf79 100644
--- a/NucuCar.Sensors/Readme.md
+++ b/NucuCar.Sensors/Readme.md
@@ -1,17 +1,15 @@
-This application will read sensors data periodically,
-provide access to it via gRPC and publish telemetry to the cloud.
+# Introduction
 
-## Installation How-To
+This module will read sensors data periodically and
+provide access to it via gRPC, while optionally publishing telemetry data into the cloud.
 
-1. Build the module and target the Raspberry Pi.
-2. Copy the files over to the Raspberry Pi.
-3. Modify `appsettings.json` to fit your needs.
-4. Install the hardware.
+For installing see instructions from the Readme.md file located at the root directory.
 
-### Wiring
+# Wiring
 
-You may download the Fritzing diagram from `Docs/fritzing/nucucar.sensors.fzz` 
-in order to play with it.
+_You may download the Fritzing diagrams from `Docs/fritzing/` in order to play with them._
+
+Wire your sensor according to the following diagram:
 
 ![alt text](../Docs/images/nucucar.sensors_bb.jpg)
 
@@ -20,13 +18,14 @@ in order to play with it.
 
 Connect the BME680 sensor to the I2C bus 1 (I2C.1) of the Raspberry Pi. 
 The address ` 0x76` will be used to communicate with the sensor.
- 
 
-5\. Run the application.
+Make sure I2C is enabled. Use `raspi-config`.
 
-### Environment Sensor
+# Sensors
 
-Worker service for the [BME680](https://www.bosch-sensortec.com/bst/products/all_products/bme680) environmental sensor from Bosh.
+#### Environment Sensor
+
+We use [BME680](https://www.bosch-sensortec.com/bst/products/all_products/bme680) environmental sensor from Bosh.
 
 Sensor capabilities: